Electrical and Air Compressor Requirements

On-Site Training Confirmation

Congratulations! Your machine comes with on-site training at no additional cost. Accu-Cut will make every effort to arrange an authorized technician to be on site within 2–4 weeks after delivery. If you need training sooner, we can arrange virtual training at no charge.

Please ensure your electrical and air compressor systems are fully set up before the training session. The on-site technician is not permitted to perform air compressor or electrical setup. On arrival, the technician will connect the air hose to the cutting machine and begin training.

If the site is not ready (incomplete electrical, insufficient air, or any condition preventing training), a $1,500 fee will be assessed to return a technician at a later date.

Machine Electrical Requirements

  • Power: 220V, single phase, 60Hz, 15A
  • Outlet: Dedicated line — NEMA 6-15R, single phase, 15A

Air Compressor Requirements

  • Air Compressor: 60-gallon, 120 psi, single phase, 5 hp, CFM 11
  • Also required: Air regulator and water separator
    An air compressor kit can be purchased through Accu-Cut Support by calling 800-222-8288

Questions? Call 800-222-8288.


By signing below, the Customer acknowledges and agrees to the above terms. The signer represents they are authorized to bind the Customer to these terms.

Address(Required)
MM slash DD slash YYYY
Clear Signature